AB Prototype P320 Tungsten Weight Kit for Wilson Combat Grips

AB Prototype P320 Tungsten Weight Kit for Wilson Combat Grips, NEW.

This is a new AB Prototype P320 Tungsten Weight Kit. Includes three, long tungsten rods ready to drop into your Wilson Combat P320 grip module. The tungsten weights add a total of 44 grams to your grip module to reduce muzzle flip and increase control. That's a 47% increase in mass of the grip. Rods easily drop into the slots in the grip, but will need to be retained by heat shrink tubing or silicon adhesive. HEAT SHRINK TUBING IS INCLUDED. This is for use in all 9mm P320 WILSON COMBAT grip modules only, does not fit SIG Sauer grip modules or Wilson Combat P365 grip modules. 

Includes: AB Prototype P320 Tungsten Weight Kit (3 pins), 2 sizes of heat-shrink tubing for installation, NEW. Factory grease may be present. No Slide, chamber flag, grip, etc. included.

Installation is available for an additional charge. 1/4" rod (larger) is installed in the center hole, 1/8" (smaller) rods are installed on the left and right. Check for interference with trigger bar spring. Some Wilson Combat grips have varying depths of holes.

Complete lower parts kit can be purchased HERE