AB Prototype P320 Tungsten Weight Kit for SIG Sauer X-Ten, NEW.
This is a new AB Prototype P320 Tungsten Weight Kit specifically for the SIG Sauer X-Ten Grip Module. Includes two, long tungsten rods ready to drop into your SIG Sauer P320 X10. The tungsten weights add a total of 20 grams to your grip module to reduce muzzle flip and increase control. Full-size X-TEN grip module weighs 96 grams. That's a 20% increase in mass of the grip. Rods easily drop into the slots in the grip, but will need to be retained by heat shrink tubing or silicon adhesive. HEAT SHRINK TUBING IS INCLUDED. This is for use in all factory 10mm P320 X10 grip modules only, does not fit other SIG Sauer or Wilson Combat grip modules.
Includes: AB Prototype P320 X10 Tungsten Weight Kit (2 pins), 1 size of heat-shrink tubing for installation, NEW. Factory grease may be present. No grip module is included.
Heat shrink tubing should cover approximately 1/2 of each rod and press into grip.
Installation is available for an additional charge.
Complete lower parts kit can be purchased HERE
2 Reviews Hide Reviews Show Reviews
-
Xten grip weights
Adds some nice heft to the grip helping to take the recoil. Would be nice if some instructions were included, but it wasn't terribly hard to figure out. Just had to use heat on shrink while on the weight then hammer it in.
-
x Ten weights
The weights fit the X Ten frame just fine. Adds a little weight to the rear.
