AB Prototype P365 Tungsten Weight Kit for Wilson Combat Grips

AB Prototype P365 Tungsten Weight Kit for Wilson Combat Grips, NEW.

This is a new AB Prototype P365 Tungsten Weight Kit. Includes three, short tungsten rods ready to drop into your Wilson Combat P365 grip module, P320 X-Compact Wilson Grip Module or SIG Sauer X-Compact Grip Module. The tungsten weights add a total of 35 grams to your P365 grip module to reduce muzzle flip and increase control. That's a 86% increase in mass of the grip (P365). Rods easily drop into the slots in the grip, but will need to be retained by heat shrink tubing or silicon adhesive. HEAT SHRINK TUBING IS INCLUDED. This is for use in all 9mm P365 WILSON COMBAT grip modules, P320 WILSON COMBAT X-Compact or SIG Sauer X-Compact only, does not fit other SIG Sauer grip modules or Wilson Combat P320 grip modules (too short). 

Includes: AB Prototype P320 Tungsten Weight Kit (3 pins), 2 sizes of heat-shrink tubing for installation, NEW. Factory grease may be present. No Slide, chamber flag, grip, etc. included.

Installation is available for an additional charge. 1/4" rod (larger) is installed in the center hole, 1/8" (smaller) rods are installed on the left and right. Some Wilson Combat grips have varying depths of holes. Heat shrink should cover 1/2-1/3 of the rods, cut-to-fit.

Complete lower parts kit can be purchased HERE