SIG P320 Manual Safety Delete Kit

SIG Sauer P320 Manual Safety Delete Kit, NEW. (USES YOUR EXISTING MANUAL SAFETY TRIGGER BAR)

This kit is used to remove the manual safety from an existing P320 with factory manual safety. Includes a new SIG P320 safety lever pin. Works with most upgraded P320s in 9mm, 40SW, 357SIG and 45ACP (for conversion or non-manual safety versions only). Keep your existing P320 manual safety trigger bar. Using the standard trigger bar is not recommended as the trigger bar will hang up in the manual safety pocket not allowing the trigger to reset. 

Removing the manual safety lever will leave the slot open in your existing grip. A standard grip without the manual safety notch is required. See grips HERE. 

Includes: SIG Sauer P320 safety lever pin, NEW (#1300674-R). Factory grease may be present. No Slide, trigger bar, chamber flag, grip, etc. included. May not include factory packaging.

Installation is available for an additional charge.

More options can be found here: USED SAFETY LEVER PIN

Complete lower parts kit can be purchased HERE

Grip modules can be found HERE

None of the Sig Sauer items in this kit have a MAP